Sample & Hold

Sample/Track & Hold.
Sample Mode: The Out signal is updated to the Input signal every time the Clock crosses the Trigger level in a negative direction.

Track Mode: When the clock input signal is less than the trigger level, the In signal passes straight-through to the Out socket. When the clock signal is greater than the trigger level, the Out signal is 'frozen' and no longer tracks the In signal.

When there no jack in the Clock socket, the LFO is routed internally to the sample & hold.

The Trigger Level range is -5 to +5 Volts, to accommodate both bipolar and unipolar trigger signals. When a saw signal is used as the clock, adjusting this level changes the timing of the internal trigger signal.

Low Frequency Oscillator.
The LFO frequency can be set manually with the Frequency control, and externally using the two CV inputs. These are both temperature compensated and have a nominal 1volt/Octave characteristic.
Three waveforms can be selected, and the output level set by the Amplitude control. A front-panel LED indicates signal polarity and level.

Key Data

LFO Output Waveforms:

Sine. Triangle & Square

LFO Frequency Range:

0.3 - 600Hz

LFO Output Level:

0-10 Vp-p

Module Depth:

30mm

Power Connector:

Doepfer 10-pin shrouded header

Current Consumption:

+12 Volts, 38mA
-12 Volts, 38mA

Reverse-Power Protection:

Yes

Panel Width:

8HP (40.6mm)

Panel Options:

White powder-coated aluminium.